Temporary treatment of tractor outage
1. The tractor often finds out the cause of the fire in the operation. One is that the diesel filter gas is dirty and the filter element is covered with sludge. Remove the filter element and clean it. Another reason is that the spring pressure of the return valve in the oil return hollow screw of the high pressure oil pump is too small or the leakage is not closed tightly, and the pressure in the pump body cannot be formed. Small cork can be used to cushion the spring to create pressure, or replace the ball.
2. Radiator breaks in and out of the water hose. If there is any breakage, use a piece of cloth to coat the leaked area with a piece of soap, and then tie it tightly with a wire. If it is severely broken, cut it into two sections with a knife from the place where the hose is broken. Bamboo tubes or plastic tubes, etc., are placed between the hoses, and then tightly tied with iron wire, and then loaded; when the radiator core copper tube has slight leakage, the leaking water can be lightly clipped by the oranges so that it does not leak water. 3. If the valve spring breaks only one break, the two break springs can be installed and used. If the spring is broken at several places, the multi-cylinder machine can remove the adjusting bolts of the inlet and exhaust valves of the cylinder and close the valve. The cylinder stopped working and cut off the oil.
4. When the power is suddenly cut off during stoppage, the speaker will not sound, the lights will be off, the starter will not turn, and so on, indicating that the vehicle is completely off. At this time, you can first check whether the pile head of the battery is loose. Do not squash when inspecting. Use a pair of pliers to test the two pile heads. If there is no spark, then the pile head is loose and tighten with a wrench. If the pile head is tightened and cleaned, the power-off phenomenon remains. If it is not eliminated, check the connection of the two-pole wires, such as poor contact, repair in time; if the battery has a single-cell damage, use the copper wire to directly connect the good cells.
5. Without jacks to replace tires, first open the bad tires to the dirt road, use a wooden block or brick, stone to stabilize the front axle or rear axle, dig the pit under the tires to be removed, make the tires vacant, you can remove change.
6. Blown Fan Tape Damaged fan tape, mostly broken. Several ropes can be used to fasten the strands. The length and thickness should be similar to those of the original fan tape. However, the ropes must be flashed in the middle and cannot be exposed. Then they can be tightly tied with iron wire; the two fan heads of the original fan tape can be broken at the same time. Holes, temporarily connected with coarse wire. However, the law should test the engine for a few minutes to check if the fan rotation is normal.
Rongcheng Jingyi Oceanic Technology Company Limited , https://www.jingyifoods.cn