Raymond mill operating method
Raymond mill operation method:
1. Before the Raymond mill starts, check whether all the inspection doors are closed tightly. Check whether the jaw gap of the crusher meets the feed particle size. Adjust the speed of the analyzer to reach the approximate grain size requirement. Finally, press in order to boot.
1. Start the bucket elevator; 2. Start the jaw crusher; 3. Start the analyzer after the material is stored in the silo; 4. Start the blower (empty load start, then load after normal operation); The Raymond Mill host starts the electromagnetic vibrating feeder immediately after starting the mainframe. At this point, Raymond grinding work is the beginning.
Second, Raymond mill operation sequence is as follows: start: hoist → crusher → analysis machine → fan → host → feeder.
3. When the Raymond mill stops, the machines should be shut down in the following order:
The order of Raymond mill shutdown is: feeder → host → blower → analyzer.
1. Close the feeder to stop feeding;
2. Stop the host after about one minute;
3. Stop the blower after blowing off the residual powder;
4. Finally shut down the analyzer. Note: After the hoist transports the material to the silo for a certain amount, stop the crusher and then stop the lifting. This item should be changed by the stock amount.
Fourth, note: Raymond mill is not allowed to refuel at regular work, to ensure production safety, abnormal noise occurs in any part of the mill, or sudden increase in load should immediately stop the inspection, troubleshooting, to avoid major accidents . When you continue to turn on the machine, you must take out the remaining material in the mill. Otherwise, the current will be too large when starting up, which will affect the startup.
1. Before the Raymond mill starts, check whether all the inspection doors are closed tightly. Check whether the jaw gap of the crusher meets the feed particle size. Adjust the speed of the analyzer to reach the approximate grain size requirement. Finally, press in order to boot.
1. Start the bucket elevator; 2. Start the jaw crusher; 3. Start the analyzer after the material is stored in the silo; 4. Start the blower (empty load start, then load after normal operation); The Raymond Mill host starts the electromagnetic vibrating feeder immediately after starting the mainframe. At this point, Raymond grinding work is the beginning.
Second, Raymond mill operation sequence is as follows: start: hoist → crusher → analysis machine → fan → host → feeder.
3. When the Raymond mill stops, the machines should be shut down in the following order:
The order of Raymond mill shutdown is: feeder → host → blower → analyzer.
1. Close the feeder to stop feeding;
2. Stop the host after about one minute;
3. Stop the blower after blowing off the residual powder;
4. Finally shut down the analyzer. Note: After the hoist transports the material to the silo for a certain amount, stop the crusher and then stop the lifting. This item should be changed by the stock amount.
Fourth, note: Raymond mill is not allowed to refuel at regular work, to ensure production safety, abnormal noise occurs in any part of the mill, or sudden increase in load should immediately stop the inspection, troubleshooting, to avoid major accidents . When you continue to turn on the machine, you must take out the remaining material in the mill. Otherwise, the current will be too large when starting up, which will affect the startup.